Connect with an electrical engineer for support, request an audit or report: 1800 623 350
  • 0Shopping Cart
Power Parameters
  • HOME
  • EQUIPMENT
    • INSTRUMENTATION
    • CRITICAL POWER
  • SERVICE
  • CALIBRATION
  • New Tech
  • Knowledge
  • About
  • Contact
  • Search
  • Menu Menu
  • LinkedIn
  • Facebook
Search
Generic filters

Or search by:

INSTRUMENTATION

CRITICAL POWER

HomeInstrumentationTransducers & EncodersAngular Position TransmittersCamille Bauer KINAX 2W2 Angular Position Transmitter
Camille Bauer KINAX 2W2 Angular Position Transmitter

Camille Bauer KINAX 2W2 Angular Position Transmitter

Specifications

Transmitter with a contact free, capacitive sensor system for the acquisition of the angular position of a shaft.

The output is a load-independent DC current signal of 4…20 mA proportional to the measured value.

Patented contact free capacitive sensor system Measuring range, direction of rotation, characteristic, switching point and other additional functions programmed using PC / Simplifies project planning and engineering, short delivery times, low stocks Measuring range of angle of rotation: 0…10 to 0…50 or 0…50 to 0…350° Measuring output (output/powering circuit) in two-wire connection (4…20 mA signal) Very low torque (< 0.001 Ncm, with 2 mm shaft) Advantage: The shaft can be rotated practically without any reaction effects and is therefore not a «load» on the connected devices. Compact size, only 48 mm diameter Advantage: it can be installed anywhere (OEM) Type of protection "Intrinsically safe" Ex ia IIC T6 / Can be mounted within the hazardous area Simulation of measured values / The testing of the subsequent device chain is already possible during the installation phase Measured value acquisition / Display of the instantaneous value and a trend graph of the measured value on the screen Adjustment / Independent fine adjustment of the analog output, zero position and measuring range Characteristic of the output value / Programmable as a linear, V-characteristic, or any characteristic curve The shaft can be turned through a full 360° Serial interface

Accessories For 2W2 configuration software

Product Resources
Datasheet Enquire about this product
  • Equipment
  • SERVICE
  • CALIBRATION
  • New Tech
  • Knowledge
  • About
  • Contact

Copyright 2020 © Power Parameters Pty Ltd | Ph: 1800 623 350 | Fx: 1800 067 263
info@powerparameters.com.au. Further information may be found at suppliers website.
Sales Terms and Conditions

Clamp Meter Calibration | Data Logger Calibration | Electrical Mechanical Calibration | Electrical Tester Calibration | Encoder Repair | High Voltage Services | Hipot Tester Calibration | Insulation Resistance Tester Calibration | Insulation Tester Repairs | Multifunction Tester Calibration | Multimeter Calibration | Multimeter Repair | Power Supply Calibration | RCD Tester Calibration | Uninterruptible Power Supply | Voltmeter Calibration

1800 623 350

Connect with an electrical engineer for support, request an audit or report.

Scroll to top